پروگرمر
MPLAB PICKIT 3.5
The PICkit 3 programmer/debugger is a simple, low-cost in-circuit debugger that is controlled by a PC running MPLAB IDE
کیفیت: Not original(copy) پکیج:
قیمت تک فروشی 12,985,440 ریال
قیمت عمده 12,369,744 ریال (10 به بالا)
قیمت ویژه 12,197,349 ریال (100 به بالا)
قیمت فوق العاده12,111,152 ریال (1000 به بالا)
قیمت تک فروشی 18.431 تتر با تخفیف
7267.265.8665.18
|
توضیحات
پروگرمر PICKIT ورژن 3.5 براي ميکروکنترلر هاي ميکروچيپ.
قابليت پروگرام کردن به صورت Off Line بدون کرش
پشتيباني از نسخه هاي مختلف نرم افزار MPLAB,MPLAB X
بدون نياز به firmware
سرعت برنامه ريزي بالاتر نسبت به ورژن هاي قبلي
با استفاده از اين پروگرامر مي توانيد انواع قديمي تا جديد ميکروکنترلرهاي PIC و DsPic را پروگرامر نماييد.
Description
The PICkit 3 programmer/debugger is a simple, low-cost in-circuit
debugger that is controlled by a PC running MPLAB IDE (v8.20 or greater) software on
a Windows® platform. The PICkit 3 programmer/debugger is an integral part of the
development engineer’s toolsuite. The application usage can vary from software
development to hardware integration.
The PICkit 3 programmer/debugger is a debugger system used for hardware and
software development of Microchip PIC® microcontrollers (MCUs) and dsPIC® Digital
Signal Controllers (DSCs) that are based on In-Circuit Serial Programming™ (ICSP™)
and Enhanced In-Circuit Serial Programming 2-wire serial interfaces. In addition to
debugger functions, the PICkit 3 programmer/debugger system also may be used as a
development programmer.
The debugger system executes code like an actual device because it uses a device
with built-in emulation circuitry, instead of a special debugger chip, for emulation. All
available features of a given device are accessible interactively, and can be set and
modified by the MPLAB IDE interface.
The PICkit 3 debugger was developed for emulating embedded processors with debug
facilities. The PICkit 3 features include:
• Full-speed USB support using Windows standard drivers
• Real-time execution
• Processors run at maximum speeds
• Built-in over-voltage/short circuit monitor
• Low voltage to 5V (1.8-5V range)
• Diagnostic LEDs (power, active, status)
• Read/write program and data memory of microcontroller
• Erase of all memory types (EEPROM, ID, configuration and program) with
verification
• Peripheral freeze at breakpoint
|
کلیه حقوق این سایت متعلق به فروشگاه Skytech می باشد